Operation Manual

1 STANDBY BUTTON

· Press this button to switch ON the CI 940. The Standby LED indicator

will turn from amber to blue.

· Pressing the Standby button again turns the unit back to standby

mode.

IMPORTANT NOTICE

The rear panel POWER switch must be in the ON position for the Standby

button to activate.

2 STANDBY LED

· This indicator will light up amber when the CI 940 is in standby

mode. When the CI 940 is powered up from standby mode, this

indicator will illuminate blue.

· At auto sense mode, this indicator will stay blue for about 10

minutes after any active input signal is shut down and then

eventually turns amber at standby mode.

3 ZONE 1, ZONE 2

· Both indicators will light up blue whenever there is an active input

signal or source connected at either ZONE 1 or ZONE 2 INPUT

terminals.

· These indicators will extinguish (no light) in the absence of active

input signal or source connected at both ZONE 1 and ZONE 2 INPUT

terminals.

IDENTIFICATION OF CONTROLS

FRONT PANEL

Multi-Channel Amplifier CI 940

1 2 3

ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ