Operation Manual

1 STANDBY BUTTON
• Press this button to switch ON the CI 980. The Standby LED indicator
will turn from amber to blue.
• Pressing the Standby button again turns the unit back to standby
mode.
IMPORTANT NOTICE
The rear panel POWER switch must be in the ON position for the Standby
button to activate.
2 STANDBY LED
• This indicator will light up amber when the CI 980 is in standby
mode. When the CI 980 is powered up from standby mode, this
indicator will illuminate blue.
• At auto sense mode, this indicator will stay blue for about 10
minutes after any active input signal is shut down and then
eventually turns amber at standby mode.
3 ZONE 1 – 4 LED INDICATORS
• Particular Zone indicators will light up blue whenever there is an
active input signal or source connected at corresponding input
terminals.
• Particular Zone indicators will extinguish (no light) in the absence
of active input signal or source connected at corresponding input
terminals.
IMPORTANT NOTICE
If the selected source is GLOBAL and there is an active source at GLOBAL’s
INPUT terminals, all four (ZONE 1-4) will illuminate at the same time.
IDENTIFICATION OF CONTROLS
FRONT PANEL
© NAD CI980
Multi-Channel Amplifier CI 980
1 2 3
6
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ