Operation Manual

iPod SETUP
The iPod Setup menu allows you to preset the following associated settings
when iPod is the selected source:
Enabled: Select “Yes” to enable iPod as a Source or “No” to disable it.
Auto Connect: Select “Yes” to automatically enable and connect the
iPod player docked in the linked NAD iPod docking station when Source
5 (the default iPod source allocation in the T 758) is selected. Select “No”
if you do not want a docked iPod to be connected automatically.
Menu Timeout: Set the time for the OSD to revert to the “Now
Playing” display when the iPod menu has been left idle (no scrolling or
navigation being done) for the specied time out time. For the “Now
Playing” OSD to be shown, there should be a song paused or being
played before going to the iPod menu. You can set the “Menu Timeout”
between the range 5s to 60s at 5s increments. If you do not want for
the menu to timeout, select “O”.
SPEAKER SETUP
After connecting all ancillary sources and other combinations, the Speaker
Setup menu will guide you on how to manage and setup your speakers in
order to achieve optimum sound acoustics in your listening environment.
The following are the Speaker Setup Menu sections.
AUDYSSEY SETUP
It has been shown that many, if not most, surround sound systems are
not accurately congured and setup. This requires special knowledge and
instrumentation that the average person probably doesn’t possess.
The T 758 has the capability to automatically setup your own unique Home
Theatre’s speaker system. This is achievable through the T 758’s Audyssey Setup
feature along with the sophisticated digital electronics built into your unit.
The installation of your new T 758 is greatly simplied by Audyssey Setup
with the end result of delivering the best quality sound possible given the
type of speakers you have as well as your listening room’s dimensions.
Audyssey Setup takes up only a fraction of time to run compared with
setting up your speakers manually and then achieve results that rival other
expensive test and setup measuring devices.
The following measurements are performed:
• Detection: Speaker conguration is detected including the number
of surround speakers and whether a subwoofer and center channel is
connected.
• Size: T 758 crossover is set based on each channel’s signal handling
capability and the subwoofer crossover is automatically set.
• Level: SPL of each speaker is matched within 1dB at the microphone
position.
• Distance: Accurately set the appropriate distance of each speaker
position as well as the subwoofer with respect to the microphone
position.
• Polarity: The setup program will detect and notify the user if any
speakers are connected improperly. Incorrect polarity can ruin the
illusion of realism oered by surround sound.
This is a one-time setup, unless speakers are moved or changed, in which
case Audyssey Setup should be performed again.
OPERATION
USING THE T 758  SETUP MENU
22
ENGLISH PORTUGUÊSFRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ