Owner`s manual

SETUP MENU
The Setup Menu allows one to customize the operation of the T 757 to the
ancillary equipment used in one’s specic AV system. Unless your system exactly
matches the factory defaults as shown in the accompanying Quick Start Guide,
you will need to use the setup menu to congure the inputs of the T 757.
At Setup Menu, the following are congurable – Source Setup, Speaker
Setup, Zone Setup, Amplier Setup, Trigger Setup, Listening Mode Setup,
Display Setup and A/V Presets.
Follow the guidelines about “DISPLAY THE OSD” and “NAVIGATING THE OSD
AND MAKING CHANGES” to navigate through the menu options and their
sub-menu selections.
SOURCE SETUP
There are three sub-menu items under Source Setup. These are Source
Setup (Normal View), Source Setup (Table View) and iPod Setup.
SOURCE SETUP (NORMAL VIEW)
The Source Setup (Normal View) menu makes it possible to set, allocate or
change the following settings.
SOURCE
The T 757 is equipped with ten congurable Sources. The settings for each
Source are dependent upon the congurations set forth in the parameters
for that particular Source window.
To change or toggle through the Sources, scroll to “Source”, press [S] button
and then ENTER or [D/F]to move up or down the Source selections.
NOTE
Source 5 is defaulted to iPod. Remove the default setting of Source 5 to
iPod via the following procedure:
1 Go to “iPod Setup” menu under the “Source Setup” menu. At “iPod
Setup” menu, set “Enabled” to “No”.
2 Then, go back to “Source Setup” menu and select “Source Setup (Normal View).
3 Go to Source 5 and set “Enabled” to “Yes”.
Source 5 can now be congured to any desired settings.
ENABLED
One can enable/disable a Source via this option. This is particularly useful
if only few Sources are used and one directly selects the Source from the
front panel, bypassing unused sources.
Select “Yes” to enable the particular Source or “No” to disable the Source.
NAME
A new Name maybe assigned to a Source label. For example, if your BD player is
attached to “Source 1”, it is possible to rename “Source 1” to “BD Player”.
In order to rename the Source label, scroll to the “Name” parameter. Press
[ S ] to go to the rst character. Then, press [ D/F ] to pick through the
alphanumeric selections.
Press [ S ] to move to the next character and at the same time save the
changes done on the current character. The name can be as long as twelve
characters.
The new Name will be shown in the VFD as well as on the OSD.
OPERATION
USING THE T 757  SETUP MENU
19
ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ