Owner`s manual

VIDEO FORMAT CONVERSION
The T 757 is equipped with a Video Format Converter. This allows for a
simplied video connection between the T 757 and your TV Monitor when
using multiple video formats such as Composite (CVBS), S-Video, and
Component (YUV). This format change is accomplished by encoding the
analog video signal into a digital signal using a very high quality digital
encoder to maintain the best possible picture quality.
Once in digital format, the video input signal could also be available at
the other Monitor output jacks including HDMI MONITOR OUT. Thus, you
do not have to necessarily assign the video output of a composite video
input signal to MONITOR OUT (Composite video). The composite video
input signal can be viewed also at HDMI MONITOR OUT at a resolution
setting dependent upon your TV/Monitor’s resolution capability. Some TV/
Monitors will automatically display the video signal at 480p/576p if they are
not capable of displaying 480i/576i.
If your TV/Monitor does not have HDMI input, select the highest quality
video format available on your TV/Monitor and utilize this as T 757’s
preferred Monitor OUT. In most cases, this will be Component Video, but on
some older TVs, S-Video maybe the best quality connection.
A/V PRESET
A particular Source can be assigned a stored Preset. The parameters set up
in the selected Preset number will be adopted into the particular Source it
is assigned (Please refer to the separate section on “A/V Presets” for further
understanding of Preset settings).
Scrolling to “A/V Preset” and by pressing [ S ] and then [ D/F ], a Source
could be assigned a Preset number ranging from Preset 1 to 5.
If it is desired not to assign the particular Source a Preset setting, select “None”.
TRIGGER OUT
The Trigger Out for a particular Source is dependent upon the
congurations done in a separate menu on Trigger Setup (See “Trigger
Setup” below).
For “Trigger Out” to become enabled and assignable at “Source Setup
(Normal View)” menu, make sure to carry out or note the following
beforehand
• In the separate “Trigger Setup” menu, assign “Trigger 1 Out” to “Source
Setup”.
• “Trigger Out” will not appear as an option at the Source Setup (Normal
View) menu if at the separate “Trigger Setup” menu, “Trigger 1 Out” is
assigned to “Main” or “Zone 2”.
Set “Trigger Out” to “On” to enable “Trigger Out” or “O’ to disable it as per
assigned Source.
SOURCE SETUP (TABLE VIEW)
The Source Setup (Table View) reects the settings made in the Source
Setup (Normal View) menu. All the Source settings are summarized and
displayed in tabulated form in the Source Setup (Table View).
Navigating through the Source Setup (Table View) via a combination
of [ A/S ] and then [ D/F ] buttons, one will have the benet of directly
changing the settings for “Audio”, “Video”, “Preset”, “Trigger” and “Source
Name” without going back to the Source Setup (Normal View) menu.
Highlight a particular Source number and then, toggle [ENTER] button to
enable or disable said Source number.
OPERATION
USING THE T 757  SETUP MENU
21
ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ