Operation Manual

SOURCE SETUP
From Setup Menu, pressing will direct you to the Source Setup menu
wherein you could adjust allocate or change the settings of the following
– Source Setup (Normal View), Source Setup (Table View) and iPod Setup.
SOURCE SETUP (NORMAL VIEW)
The Source Setup (Normal View) menu makes it possible to set, allocate or
change the following settings.
SOURCE
The T 785 is equipped with ten congurable Sources. The settings for each
Source are dependent on the congurations set forth in the parameters for
that particular Source window.
To change or toggle through the Sources, scroll to ‘Source’, press button
and then ENTER or to move up or down the Source selections.
NOTE
 Source5isdefaultedtoiPod.ForSource5tobechangedandallocated
forotherinputs,goto‘iPodSetup’menuunderthe‘SourceSetup’menu.
AtiPodSetupmenu,set‘Enabled’to‘No’–youcannowassignSource5
to other inputs or settings as desired.
ENABLED
One can enable/disable a Source via this option. This is particularly useful
if only few Sources are used and one directly selects the Source from the
front panel, bypassing unused sources.
To enable or disable a particular Source, scroll to ‘Enabled’ and press
keys to select ‘Yes’ or ‘No’.
NAME
A new Name maybe assigned to a Source label. For example, if your DVD player
is attached to ‘Source 1’, it is possible to rename ‘Source 1’ to ‘DVD Player.’
In order to rename the Source label, scroll to ‘Name’ and press to go the
character. Then, press to pick through the alphanumeric selections.
Press to move to the next character and at the same time save the
changes done on the current character. The name can be as long as twelve
characters.
The new Name will be shown in the VFD as well as on the OSD.
ANALOG AUDIO
The T 785 has nine analog audio inputs including 7.1 input. These analog
inputs - Audio 1, Audio 2, Audio 3, Audio 4, Audio 5, Audio 6, Audio Front,
Audio MP and 7.1 Input can be variably assigned to each Source.
Scroll to ‘Analog Audio’ and then press and then to select and assign
an analog audio input to the particular Source. There are three choices
– Audio, 7.1 Input or O.
When ‘Audio’ is chosen, press and then keys to select and assign the
desired audio input – 1 to 6, Front and MP.
Select ‘7.1 Input’ to choose the audio signal fed to ‘7.1 Channel Input.’ If ‘O’
is selected, no incoming analog audio signal is selected by the particular
Source.
NOTE
 Anincomingdigitalsignalpresentattheassigneddigitalinputwill
alwaystakeprecedenceovertheassignedanalogaudioinput,evenif
botharepresent.Tomaintaintheanalogaudioinputfortheparticular
Source,select‘O’atthe‘DigitalAudio’settingofthesame‘Source’
menu.
OPERATION
USING THE T 785  SETUP MENU
19
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ