Operation Manual

3 Press [ENTER].
4 Press [MENU] button of HTRC 1 – [MENU] button of the HTRC 1 is where
the corresponding [MENU] function key of the TV remote control will be
learned.
5 Press and hold the corresponding [MENU] button of the TV remote
control until “Success” is shown in the display. (Refer also to “MODE”
discussion below).
6 “Success” will be shown in the display if the [MENU] function key is
successfully “learned.” You can now release the [MENU] button of the TV
remote control.
7 Wait until “Success” is extinguished from the display to complete the
process.
NOTE
 “Failed”willbeshowninthelowerlinedisplayifthe“learning”ofthe
desiredfunctionkeyisunsuccessful.RepeatStep3–7againuntil
“learning”ofthedesiredkeyissuccessful.
MODE
There are three modes on how a function key can be learned. Press and hold
[TUNER (10+/SETUP)] and [ENTER] buttons. Use [ ] to scroll to “Learn”. Press
[ENTER] and then [ ] to scroll to “Mode”. The following are the three modes:
Normal: This is the regular learning mode. A function key is learned until
“Success” is shown in the display. The example above is at “Normal” learn mode.
2 Pass: Some remote controls use an IR (infrared) “toggle bit”. This means
that if you press the same key twice in a row, the IR signal toggles between
two dierent variations of the same command.
At “2 Pass” mode, step 5 and onwards of the above example would be as
follows (the same Steps 1 – 4 of the above example applies)
5 Press and hold the corresponding [MENU] button of the TV remote
control.
6 Release [MENU] button.
7 “Pass 2” means that you have to press [MENU] button again. Press until
“Success” is shown in the display.
8 “Success” will be shown in the display if the [MENU] function key is
successfully “learned.” You can now release the [MENU] button of the TV
remote control.
9 Wait until “Success” is extinguished from the display to complete the
process.
Narrow: Some remote controls use very narrow pulses of IR. If you cannot
get your remote to work using the normal or 2 Pass modes, you may want
to try this mode. The same example above for “Normal” mode applies to
“Narrow” mode.
PUNCH-THROUGH (Pun Thr)
The HTRC 1’s “Punch through” function allows you to retain a function key
from one DEVICE SELECTOR “page” to another.
Example: Punch-through “SURR MODE” key to the “DVD” page.
1 Press [DVD] in the DEVICE SELECTOR page.
2 Press and hold [TUNER (10+/SETUP)] and [ENTER] buttons. Use [ ] to
scroll to “Pun Thr”.
3 Press [ENTER].
4 Press [SURR MODE] button – this is the function key that will be
punched through.
OPERATION
USING THE HTRC 1 REMOTE CONTROL
44
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ