Owner's Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- INTRODUCTION
- IDENTIFICATION OF CONTROLS
- OPERATION
- USING THE T 758 - MAIN MENU
- USING THE T 758 – SETUP MENU
- SETUP MENU
- CONTROL setup
- SOURCE SETUP
- SPEAKER SETUP
- SPEAKER CONFIGURATION
- SPEAKER LEVELS
- SPEAKER DISTANCE
- DIRAC LIVE
- ADJUSTING THE VOLUME
- ZONE 2 SETUP
- AMPLIFIER SETUP
- TRIGGER SETUP
- LISTENING MODE SETUP
- LISTENING MODEs
- DOLBY SETUP
- DTS SETUP
- ENHANCED STEREO
- front panel DISPLAY SETUP
- A/V PRESETS
- BluOS SETUP
- SELECT LANGUAGE
- SYSTEM INFO
- REFERENCE
ENGLISH
28
3 At “A/V Presets” page, set “Preset: 1” to the following conditions - use
[ D/F ] to select “Yes” and press [ENTER] to conrm selection and move
on to the next setting.
While at “Save Current Setup to Preset” menu line, use [ S ] to save the
above settings to Preset 1. Below OSD will be shown, arming that the
above settings are now saved to “Preset 1”.
When you recall “Preset 1” using the remote control (for AVR4, “A/V
PSET” + “1”), the above preset values allocated at “Preset 1” (preset
settings as shown in the OSD captures at Step 1) will be recalled and
eected at the current source.
4 Now, repeat again Step 1 above but this time with the following
settings
Listening Mode Setup: Listening Modes/Dolby Digital/Stereo/None
DSP Options: 5ms
Tone Controls: Tone Defeat/On
Front Panel Display Setup: Set “Line 2” to “Audio Source Format”
5 With the above settings, scroll to “A/V Presets” from the SETUP MENU
page. Use [ S ] to access “A/V Presets” menu.
OPERATION
USING THE T 758 SETUP MENU