Operation Manual

CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONS
No sound from all channels. • AC power unplugged. • Check AC cable connection and outlet.
• Power not switched on.
• Outlet has no power.
No sound from some channels. • Faulty/missing cables. • Check cables.
• Speaker connections faulty. • Check speaker connections.
• “Speaker Settings” channel (s) set to “O”. • Check “Speaker Settings” menu.
No sound from Subwoofer. • Subwoofer is o, not powered or improperly
connected.
• Power-up subwoofer, check Sub’s AC outlet
or check connections.
• Sub level set too low. • Correct subwoofer level by adjusting “SUB”
button at HTR 6.
VISO TWO does not respond to HTR 6
remote control.
• Batteries are at or incorrectly inserted. • Check batteries.
• IR transmitter window on remote or IR receiver
window on VISO TWO is obstructed.
• Check IR windows and ensure clear line-of-
sight from remote to VISO TWO.
• VISO TWO front panel is in very bright sunlight
or ambient light.
• Reduce sunlight/room lighting.
VISO TWO does not respond to front panel
commands or remote control.
• Microprocessor error. • Power down the VISO TWO via the front
panel Power button and unplug it from the
AC outlet.
• VISO TWO may have over heated. • Wait ve minutes, re-connect and power up.
The POWER is ON, but the internal DVD
player does not work.
• No disc is inserted. • Insert a disc.
No picture. • The TV is not set to receive video signal. • Select the appropriate video input mode
on the TV so that the picture from the
VISO TWO appears on the TV screen output.
• The video cable is not connected securely. • Connect the video cable into the jacks
securely.
• The connected TV power is turned o. • Power on the TV.
• HDMI connector is plugged-in and “HDMI Res.”
is set to 720P, 1080I or AUTO.
• Unplug HDMI cable connected to rear
panel’s HDMI OUT.
• At DVD mode and with no disc loaded (“NO
DISC”)
1 Press and hold [DISPLAY] button. The lower
line of the VFD will show the current HDMI
resolution setting.
2 Use the remote’s [ ] keys or toggle
[MEMORY] button to select through
480P/576P, 720P, 1080I, AUTO or OFF.
Select either “480P/576P” or “OFF” to enable
component video out, composite and S-Video
output. Stop at your desired resolution setting
and release [ ] keys or [MEMORY] button.
The playback picture is poor. • The disc is dirty. • Clean the disc.
The internal DVD player does not start
playback.
• No disc is inserted. • Insert a disc
• An unplayable disc is inserted. • Insert a playable disc (Check the disc type
colour system and Regional code).
• The disc is placed upside down. • Place the disc with the playback side down.
• The disc is not placed within the guide. • Place the disc correctly inside the guide on
the disc tray.
• A menu is on the TV screen. • Press SETUP button of HTR 6 to turn o the
menu screen.
• The disc is dirty. • Clean the disc.
Parental Control cannot be changed. • The password entered was wrong. • Enter the correct password.
• Password was forgotten. • Set the VISO TWO to factory default settings.
1 Place the VISO TWO into AM mode.
2 Press quickly the three front panel buttons;
[PLAY/PAUSE] then [STOP] then [DISPLAY],
holding the [DISPLAY] button for more than
7 seconds. The VISO TWO will switch itself
o then back on to DVD mode.
Note: Default password is 2580.
REFERENCE
TROUBLESHOOTING
32
ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ