Use and Care Manual

Page 10
SITUATION VERIFICATION
VACUUM WON’T
START OR STOP
Hose on/off switch
Opon 3:
Opon 4:
The pin’s spring could be broken
When seng the hose switch to ‘’OFF’’, you must wait 3 seconds before the vacuum shuts down. If you
pressed the ‘’ON/OFF’’switch quickly many me; The vacuum will seem to always stay on. Set the switch to
‘’OFF’’ and wait 3 seconds, the unit should stop.
Hose not properly plugged in
Make sure to properly plug the hose in the inlet. ( See the picture to see proper plug-in method)
Make sure the black part is well aligned
in the middle of the 2 small pins
If the pins, once pushed, do not come up; the spring is probably
broken and could
cause the vacuum not to start or stop. In which case the spring must
be fixed.
If all of the above work, please proceed to bypass. If the vacuum starts, see the
Technician as there is a problem with the cable.
SITUATION VERIFICATION
HOW TO DO
A BYPASS TO
TEST THE
VACUUM
Step 1
OR
Use wire or paper clip
Step 2
Step 3
Insert 1 side of the wire, or paper clip, in the black inlet and the other one in the red inlet
Remove the wire and wait 3 seconds - Unit should stop..
Unit should start
FAQ and Trouble Shooting Guide available on our web site at:
USA: nadair.com/vacuum/trouble-shooting/
Canada: nadair.ca/vacuum/en/trouble-shooting/
Since1980