Use and Care Manual

Page 7
4. INSTALLATION (Cont.)
5. Connect your low-voltage wire
Step-1
If using Hard pipe
Step-2 Step-3 Step-4
6. Plug-in your vacuum
Plug your vacuum into a regular electrical outlet. The LED light will flash green and become solid green
Your vacuum is ready to be used.
Note: Never connect more than 1 wire into the Low-Voltage socket
- Connect one side of this wire with all the other
wires by connecting all the positive sides
together and all the negative
Sides together
IF YOU HAVE MULTIPLE INCOMING WIRES, FOLLOW STEP 5.1 TO 5.5
Step 5.1 Step 5.2 Step 5.3 Step 5.4 Step 5.5
Inlet wire
New wire
- Connect the other side of your new wire
(conductors) into the low-voltage socket on
the vacuum while simultaneously pushing on
their respective button.
- Give a light pull to the wire to make certain
that it is well secured in the terminal.
- Than, secure each side
With electrical tape
We suggest to use flexible pipes ( SOLD SEPARATELY) For faster and easier installation
- Connect one side of the flex pipes
to the Piping network. Secure it with the ring.
DO NOT GLUE
This method requires: Cement, 2’’ PVC pipes, Sweep Elbows, Couplings
- In the top air intake of the vacuum,
Insert a coupling. DO NOT GLUE
- Insert a 2’’ PVC pipe piece in the top
Air intake coupling DO NOT GLUE
- Connect the other end of your flex pipe to the
PVC pipe piece and secure it with
Provide metal ring ( NEVER USE GLUE)
NOTE: Our flexible pipes are 12’’ long and comes in a set of 2 with connection pieces . You can connect two (2) flex pipes together by using the PVC pipe pieces
and the provided metal ring. (NEVER USE GLUE) -
OUR FLEXIBLE PIPE KIT IS SOLD SEPARATELY
- First, Take a new low-voltage wire
And strip the conductors for about
3/8’’ (10 mm).
(Live ( negative side) in the black terminal
And neutral (positive side) in the red terminal)
- To remove the conductors out of
The terminals, lightly Push the
Button as you are simultaneously
Gently pulling the wires out.
4. Connect the top air and debris intake pipe to the PVC piping network
Push Push
Pull Gently
LED light
1st, you must determine the trajectory of your piping
Than you must glue pipes and elbows together all the way to the top air intake
IF YOU HAVE ONLY 1 INCOMING WIRE, FOLLOW STEP 5.1, 5.4 AND 5.5
Scan to purchase Flex pipe
or piping installation kit
on our web site
US web siteCanada web site
Since1980