User Manual

27 28
General settings
1/ Scan the follow barcode to restore factory default settings,
Restore defaults
After restoring the default settings,you need to set the UART module,scan the following
barcode
①UART 9600，NO，8，1
2/ Scan one of the following barcode to select mode,
a ) Manual Trigger Mode
b) Continuous Mode
When in Manual Trigger Mode,you could activate the scanner by pressing the external
hardware trigger.When the hardware trigger is released,the data will be uploaded.
When in Continuous Mode, the laser is always on. Once a barcode has been read,the
scanner will upload the barcode automatically. You do not need to manually press
hardware trigger.
3/ Scan one of the following barcode to select the voice mode
a )Open the buzzer b) Close the buzzer
4/ to set the sleep time
First,Scan the following barcode to enter into sleep time setting,
Into sleep time setting
Second,scan one of the following barcode to set the time interval,when it's idle
exceeding the time interval you set,the scanner will enter into sleep mode.
a) 30second
b) 2 minutes
c)10 minutes
d) no sleep