User Manual

5 6
Note：
Not connected status: Only the green indicator light is on
Under matching mode:The green indicator light is on ,the red light and the blue light is
flashing.
Connected status:the buzzer range “di di”The red light goes out, the green light and
blue light is on.
Question 1
when the red indicator light goes out ,the blue light and the green light is on.it means
that the scanner is successfully paired with your device. but the barcode does not
appear in the location of cursor
Solution
1.The scanner maybe set to storage mode or SPP Mode.
Please scan the following code in order to reset it：
1) “restore default” (on page 27)
2) “①UART 9600，NO，8，1” (on page 27)
3) “Instant upload mode” (on page 29)
4) “HID mode” (on page 31)
2.The possible reason is that the setting is off by default，for some barcode types are
not commonly used.
Please go to page 36 to activate a specific barcode type to get it to work .
Or please contact our customer service at [e-mail] for further assistance if
you do not know the exact type of barcode that you are referring to
Question 2
It working intermittently,the scanner always turns into automatic sleep.
Solution
Default sleep time is 30 secinds,You could set idle interval out to be 10minutes ,when
it's idle exceeding 10 minutes,the scanner will enter into sleep mode. or you could set it
into no sleep mode. Operation please see page 28.
2 / Pairing Guidance with Bluetooth-enable android phone
Step 1.
Press the button to wake the scanner,the scanner will beep fast “di di di” and
the green light will turn on.
Step 2.
Scan the following‘Match’ bar code,till blue light and red light flashing at the
same time, which means the scanner is under matching mode.
Match
Step 3.
Enabling Bluetooth on your device, Tap the On/Off toggle if it's gray to turn it
on.Till finding “General Bluetooth HID Barcode Scanner”, and click it to begin
Bluetooth pairing.