O W N E R ’S M A N U A L UWS -100 100-Channel Select UHF Wireless System
Contents Introduction.............................................................................................................................. 2 Using this Manual..................................................................................................................... 2 System Features...................................................................................................................... 3 Quick User Controls Guide................................................................
One Year Limited Warranty System Features Nady Systems, Inc. warrants to the original consumer purchaser that the unit is free from any defects in material or workmanship for a period of one year from the date of original retail purchase. If any such defect is discovered within the warranty period, Nady Systems, Inc. will repair or replace the unit free of charge, subject to verification of the defect or malfunction upon return to Nady Systems.
Quick User Controls Guide Frequency Plan UWS-100 Receiver: Front View Band 1: 667.000-696.700MHz (U.S.) 100 Channels / 300 KHz per step Channel 1 UWS-100 UHF PLL WIRELESS SYSTEM DigiTRU Diversity™ ASC™ SYSTEM A AF RF A SEL ECT CHA NNEL 2 3 B 4 B IR 5 ASC 6 00 10 20 30 40 50 60 70 80 90 00 667.000 670.000 673.000 676.000 679.000 682.000 685.000 688.000 691.000 694.000 01 667.300 670.300 673.300 676.300 679.300 682.300 685.300 688.300 691.300 694.300 02 667.600 670.
Specifications OVERALL SYSTEM PERFORMANCE Operating Frequency Range Freq. Synthesized PLL system frequency stability Frequency Response Dynamic Range Harmonic Distortion Modulation Operating Range UWS-100 RECEIVER Receiver System 1. 2. 667.0MHz-696.7MHz (U.S.) (100 channels switchable) 300kHz/step <0.005% 50Hz-18kHz +/-3dB 120dB <0.
Quick User Controls Guide Miscellaneous Tips UHT-100 Handheld Transmitter: Front and Back 15 16 17 16A • The receiver antennas should be kept away from any metal surfaces whenever possible as they can reflect away or shield the incoming RF signal. • If the receiver’s volume control is set too high, it may overdrive the input of the attached audio mixer, causing distortion.
Cautions and Troubleshooting Quick User Controls Guide Feedback UB-100 Bodypack Transmitter Please also note the pickup pattern characteristics of the microphone selected. Unidirectional microphones are more resistant to feedback. However, they pick up sound sources best that are directly in front of the microphone.
System Operation UWS-100 Receiver Powering the Receiver To power the receiver, plug the provided DC POWER SUPPLY UNIT (14) adapter into the DC INPUT JACK (8) on the back of the receiver, then plug the adapter into a 120VAC outlet. Note: Any 15-18VDC source with minimum 400mA capacity can also be used. The Power Rocker Switch (9) is used to turn the receiver on or off. To turn on, press down the right side of the switch (“I”). The LED Display (3) will light, showing Channel 00‑99.
UBT-100 Bodypack Transmitter (LT, HM or GT) Setting up the Transmitter The UBT-100 bodypack requires two alkaline or NiMH AA batteries to operate (do not mix types). To install the batteries into the battery compartment, press at the arrow end and slide down and remove the Latching Battery Compartment Door (30), exposing the Battery Compartment (31). Insert two fresh AA batteries according to the correct polarity as indicated on the transmitter body.
Note: Only one transmitter can be used with one receiver. It is not possible to use two transmitters on the same frequency and mix the output of these transmitters into one wireless receiver. Your UWS-100 receiver is now operational and ready to use. Proceed to the following instructions for the UHT-100 handheld microphone transmitter or UBT‑100 bodypack transmitter included with your system.
