MM-15USB Mini mixer Owner’s Manual
Contents Features........................................................................................ 2 Warning......................................................................................... 3 Installation..................................................................................... 4 1. Inspection................................................................................... 4 2. Power Connection......................................................................
Warning When using this electronic device, basic precautions should always be taken, including the following: 1. Read all instructions before using the product. . Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool, etc.). 3. This product should be used only with a cart or stand that will keep it level and stable and prevent wobbling. 4.
Installation INSTALLATION To ensure years of enjoyment from your NADY AUDIO . MM-15USB mixer, please read and understand this manual thoroughly before using the unit. 1. INSPECTION Your NADY AUDIO MM-15USB was carefully packed at the factory in packaging designed to protect the units in shipment. Before installing and using your unit, carefully examine the packaging and all contents for any signs of physical damage that may have occurred in transit.
Controls & Connections 2 12 11 1 1. CHANNEL SECTION (1) MIC INPUT This electronically balanced XLR input is designed to accept signals from any balanced or unbalanced low impedance (Low Z) microphone. The XLR jack is configured for: Pin1 = ground, . Pin2 = positive (+), Pin3 = negative (-). 4 (2) LINE INPUT This 1⁄4” input is designed to accept balanced or unbalanced linelevel signals such as those from keyboards, drum machines, or samplers.
Controls & Connections (6) EQUALIZER CONTROLS All channels are fitted with a three-band EQ - HIGH, MID, and LOW. All three bands have up to 15 dB of cut and boost, with a center detent for OFF. The frequency response is flat when all three EQ knobs are in the center detent position. The HIGH and LOW shelving controls have their frequencies fixed at 10KHz and 80Hz respectively. The MID control has a peaking response at 2KHz.
Controls & Connections 13 22 (15) MAIN TO REC/USB OUT SWITCH This switch enables the Main left and right signals to be sent to the 1⁄8” mini output, rear panel Record Outputs, and the USB output. 14 (16) AUX TO REC SWITCH This switch enables the channel Aux Send signals to be sent to the 1⁄8” mini output, rear panel Record Outputs, and the USB output. Both the Main left and right signals and the Aux Send signals can be simultaneously sent to these outputs if both switches (15 & 16) are enabled.
Controls & Connections 24 29 28 27 23 25 26 Master Input/Output Section 3. MASTER INPUT / OUTPUT SECTION there is no output at the 1⁄8” output. (23) AUX SEND The Aux Send jack provides a mono mixed signal from the input channels, which can be connected to an external effects unit or other devices. The signal is adjusted by the channel Aux Send(7) controls of each channel and is post channel level control.
Controls & Connections 35 34 32 4. REAR PANEL (30) RECORD OUT The Record Out Left and Right RCA jacks provide signal output to recording devices, home audio equipment, or external amplifiers. These outputs take the signal from the Main bus, the Aux Send bus, or a combination of both depending on the positions of the Main To Rec/USB(15) and Aux To Rec(16) switches.
Specifications BALANCED XLR MIC INPUTS CH. 1-2 Maximum Total Gain (EQ’s @ mid): +63dB Maximum Input: +6.5dBu Input Impedance: 1.2kΩ Sensitivity: -53dBu ⁄8” MINI-JACK STEREO INPUT Maximum Total Gain: +17dB Input Sensitivity: +5.5dBu Input Impedance: 10kΩ 1 ⁄8” MINI-JACK STEREO OUTPUT Maximum Output: +9.5dBu/ +7dBu Output Impedance: 4kΩ 1 BALANCED TRS LINE INPUTS CH.
Notes 11
Service For Your NADY AUDIO Product (U.S.) Should your NADY AUDIO product require service, please contact the NADY Service Department via telephone at (510) 652-2411, or e-mail at service@nady.com. (International) For service, please contact the NADY AUDIO distributor in your country through the dealer from whom you purchased this product. Do not attempt to service this unit yourself as it can be dangerous and will also void the warranty. NADY SYSTEMS, INC. 6701 Shellmound Street, .