Manualshelf

- Nady PEQ-5B 5-BAND PARAMETRIC EQUALIZER OWNER'S MANUAL

ManualsBrandsNady Systems ManualsStereo EqualizerPEQ-5B
12345678910
REAR PANEL
11. BALANCED SIGNAL INPUT JACKS (1/4" TRS & XLR)
These 1/4" TRS (Tip/Ring/Sleeve) and XLR jacks are wired
for balanced input signals (0.775V=0dBm, 15K Ohms)
and signal polarity is Tip/Pin 2 = Cold (+), Ring/Pin 3 =
Hot (-), and Sleeve/Pin 1 = Ground.
12. BALANCED SIGNAL OUTPUT JACK (1/4" TRS & XLR)
These 1/4" TRS and XLR jacks provide a balanced signal out-
put (600 Ohms) and are wired with the same signal polarity
as the Input Jacks above.
13. POWER CONNECTOR
The IEC cord connector is used to connect the AC power
source to your power amplifier.
CAUTION: DO NOT REMOVE THE CENTER GROUNDING PIN.
15
14. AC FUSE HOLDERS
This fuse holder contains an AC primary fuse. When this fuse
blows, replace it with the same type fuse, size and power rat-
ing (120 VAC: 250mA/250V; 230 VAC: 125mA/250V). If it
continuously blows, stop replacing the fuse and refer servicing
to qualified personnel.
CAUTION: After checking the AC supply voltage, be sure that
the correct fuse is in the fuse holder.
15. AC VOLTAGE SELECTOR SWITCH
Before plugging in the power cord, check to see that the unit
is set for the proper voltage for your area: ~115V (60Hz) or
~230V (50Hz).
16. GROUND WIRE SCREW
Connect a short ground wire from this screw to the grounding
point for all connecting equipment in your rack (see also sec-
tion A 6 above: Chassis Grounding).
16
14
12
11
13
7