URR-10 UHF Wireless Microphone System URR-10 RECEIVER UB-10 BODYPACK TRANSMITTER UH-10 HANDHELD MICROPHONE NADY SYSTEMS, INC. 6701 Shellmound Street Emeryville, CA 94608 USA Tel: 510.652.2411 • Fax: 510.652.5075 E-mail: service@nadywireless.com www.nadywireless.
CONTENTS Nady wireless systems are type accepted under FCC rules, parts 90, 74 and 15. This device complies with RSS-210 of Industry & Science Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference; and (2) this device must accept any interference received, including interence that may cause undesired operation. CONTENTS ............................................................................................. 3 INTRODUCTION ....................
INTRODUCTION Thank you for purchasing a Nady URR-10 Diversity Wireless Microphone System and congratulations on your choice.
URR-10 RECEIVER 1. Rackmounting the Receiver The URR-10 is supplied with RACK EARS (17) which can be attached with the screws provided on the front of the side panels to enable rackmounting the receiver. (Note: Do not mount the receiver in a rack directly above an amplifier or other source of high heat–this could degrade the performance of the URR-10. Always ensure adequate air flow and heat dissipation in any rack configuration.) 24 34 26 3.
. Connecting the Audio Output The URR-10 receiver provides both a fixed mic level BALANCED AUDIO OUTPUT XLR (14) and an adjustable line level UNBALANCED AUDIO OUTPUT 1/4" JACK (13). The level from the UNBALANCED OUTPUT is controlled by the front panel VOLUME CONTROL (6) and the rear panel LEVEL LOW/HI SWITCH (12). This switch adjusts the maximum volume of the level range controlled by the VOLUME CONTROL.
The AF LEVEL LED DISPLAY (5) on the URR-10 receiver will light up to 5 LEDs for all input signals. Occasional flickering on and off during use of the top red LED indicator in this display is normal, however if the red LED stays on continuously, turn down the instrument volume or the INPUT LEVEL CONTROL (33) on the UB-10 transmitter, or noticeable distortion may result. (Note: Scratchy noises can sometimes occur when some electric guitars with dirty pots or connections are used with any wireless system.
UH-10 HANDHELD MICROPHONE UB-10 BODYPACK TRANSMITTER 1. Unscrew the BATTERY COMPARTMENT COVER (19) and remove, exposing the BATTERY HOLDER (20). Insert a fresh 9V ALKALINE BATTERY (21), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. A fresh alkaline battery can last up to 10 hours in use, but in order to ensure optimum performance, it is recommended that you replace the battery after every 7-8 hours of use. 2.