Dual Receiver VHF Wireless Microphone System
CONTENTS CONTENTS ....................................................................................................2 INTRODUCTION .............................................................................................2 USING THIS MANUAL .....................................................................................2 SYSTEM FEATURES ..........................................................................................3 ENC-DUET RECEIVER .....................................................
SYSTEM FEATURES • Dual channel system for simultaneous operation of two transmitters • Available on two selected frequencies in the VHF high band (171-216 MHz) for interference‑free, long‑range performance • Proprietary companding circuitry for an industry-best 120dB Dynamic Range, and the clearest, most natural sound available • Operating Range: Up to 250 feet typical (depending on site conditions)— up to 500+ feet line-of-sight • Noise-free transmitter ON/OFF operation • Rugged, foam-padded traveling case
ENC DUET RECEIVER 1. Rackmounting the Receiver There are two options available for rackmounting the Enc-DUET receiver: singly or side‑by‑side with another Enc Series receiver. a. Single mounting: Remove the receiver SIDE MOUNT CLIP (1) from each side of the receiver (as shown) and slide in the optional ERM-12 RACK EARS (9). b.
. Connecting the Audio Output The Enc-DUET receiver provides both a fixed mic level BALANCED AUDIO OUTPUT XLR (14) for each channel and an adjustable line level A + B UNBALANCED AUDIO OUTPUT 1/4" JACK (13) which provides a mixed (summed) Ch A plus Ch B output signal. The mixed level from the A + B UNBALANCED OUTPUT is controlled by the rear panel VOLUME CONTROLS (6) for each channel.
16 16 7 4 8 2 14 6 13 11 6 5 5 14 4 2 15 1 9 9 1 12 10 12 6
WHT HANDHELD MICROPHONE TRANSMITTER 1. Unscrew the BATTERY COMPARTMENT COVER (17) and remove, exposing the BATTERY HOLDER (18). Insert a fresh 9V ALKALINE BATTERY (19), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. A fresh alkaline battery can last up to 16 hours in use, but in order to ensure optimum performance, it is recommended that you replace the battery after every 10 hours of use. 2.
21 20 18 19 17 8
WLT LAVALIER/LAPEL OR HEADWORN MICROPHONE BODYPACK TRANSMITTER 1. Snap open the BATTERY COMPARTMENT (22) and insert a fresh 9V BATTERY (23), observing the correct polarity. Close the compartment. 2. The WLT is provided with a 3.5 mm LOCKING JACK (24) for connecting the microphone. Plug in either the LAVALIER/LAPEL (25) or the HEADWORN MICROPHONE (26), as supplied. To secure the connection, turn the metal slip ring on the plug clockwise to thread it on to the jack. To unplug, reverse the process.
24 29 28 W T BA HI 27 MIC N Y/O DB TAN F/S OF LO 22 25 26 22 Opening Battery Compartment 23 10
WGT INSTRUMENT BODYPACK TRANSMITTER 1. Snap open the BATTERY COMPARTMENT (30) and insert a fresh 9V BATTERY (31), observing the correct polarity. Close the compartment. The WGT is provided with a 3.5 mm LOCKING JACK (32) for connecting the INSTRUMENT CABLE (35). To secure the connection, turn the metal slip ring on the plug clockwise to thread it on to the jack. To unplug, reverse the process. Slip the transmitter into a pocket or clip on to your clothes or instrument strap.
35 34 33 32 30 30 Opening Battery Compartment 31 12
SPECIFICATIONS ENC-DUET OVERALL SYSTEM PERFORMANCE Frequency Response 25-20,000 Hz, +/-3dB Dynamic Range 120dB Total Harmonic Distortion < 0.3% RF Carrier Frequency Range 2 channels between 169-216 MHz Frequency Stability +/- 0.005%, crystal controlled Modulation FM (F3E), +/-20KHz max. Operating Range Up to 250 ft. typical (depending on site conditions); up to 500+ feet optimum line-of-sight ENC-DUET RECEIVER Reception Mode Controls Connectors LED Indicators Dimensions (Max.
SERVICE INFORMATION In the U.S. If you are experiencing operational problems with your system, please refer to the Support page at www.nady.com for assistance. Should your wireless system require service, please contact the Nady Service Department at (510) 652-2411 to obtain a Return Authorization (R/A) Number and service quote (if out of warranty). Make sure the R/A Number is clearly marked on the outside of the package that you are returning.
ONE-YEAR LIMITED WARRANTY Nady Systems, Inc. warrants to the original consumer purchaser that the unit is free from any defects in material or workmanship for a period of one year from the date of original retail purchase. If any such defect is discovered within the warranty period, Nady Systems, Inc. will repair or replace the unit free of charge, subject to verification of the defect or malfunction upon return to Nady Systems.
Nady Wireless Systems are type accepted under FCC rules parts 90, 74 and 15. The device complies with RSS-210 of Industry & Science Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. 6701 Shellmound Street | Emeryville, CA USA 94608 T 510.652.2411 | F 510.652.5075 | www.nady.
