User's Guide

5
6) To start the NSCaster device, just press the power button on the NSCaster device as shown below:
7) After the NSCaster device is started, it will enter the main interface of NSCaster as shown in the
following figure:
8) The SDI video signal and HDMI video signal are directly loaded into the main interface.
9) To load NET signal,select " " in the NET channel and enter the stream in the pop-up stream
edit box.
10) To load DDR signal, select the DDR button in the DDR alternate video window, and select one of
the video sources, then click Play to load the video into the DDR channel.
11) Select the output channel and press the record button " " to start record.
12) To start switching, tap once on the channel you want (SDI-1,SDI-2,HDMI-1,HDMI-2,NET,DDR)
and it will switch to PGM.