User's Manual

following two conditions : (1) this device may not cause interference, and (2) this device must accept
20. WARNING: The appliance coupler is used as disconnect device, the disconnect device shall remain
readily operable.
21. When the apparatus is not in use or during its relocation, take care of the power cord and plugs;
e.g. tie up the power cord with cable tie or similar. The tie must be free from sharp edges and the
like that might cause abrasion of the power cord. When put into use again ensure the power cord
and plugs are not damaged. If any damage is found the power cord and plugs should be replaced by
items either specied by the manufacturer or that have same characteristics as the original items.
22. This equipment is a Class II or double insulated electrical
appliance. It has been designed in such a way that it does not
require a safety connection to electrical earth.
23. This lightning ash with arrowhead symbol within an equilateral
triangle is intended to alert the user to the presence of non-
insulated “dangerous voltage” within the product’s enclosure that may be of sucient
magnitude to constitute a risk of electric shock.
WARNING: To reduce the risk of electric shock, do not remove cover (or back) as there are no
user-serviceable parts inside. Refer servicing to qualied personnel.
The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance instructions in the literature
accompanying the appliance.
24. CAUTION: To prevent electric shock hazard, replace grille. (CSA 60065, clause 5.3A)
This product can be recycled. Products bearing this symbol must NOT be thrown away
with normal household waste. At the end of the product’s life, take it to a collection point
designated for recycling of electrical and electronic devices. Find out more about return
and collection points through your local authority. The European Waste Electrical and
Electronic Equipment (WEEE) Directive was implemented to dramatically reduce the
amount of waste going to landlls, thereby reducing the environmental impact on the
planet and on human health. Please act responsibly by recycling used products. If this product is still
useable, consider giving it away or selling it.
FCC Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help.
Only operate the device in accordance with the instructions supplied. This device complies with FCC
radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of
exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less
than 20cm (8 inches) during normal operation. Changes or modications not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equipment.
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
any interference, including interference that may cause undesired operation of the device.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and
compliance with RSS-102 RF exposure. Users can obtain Canadian information on RF exposure and
compliance.
ATTENTION
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
CAUTION
RISK OF
ELECTRIC SHOCK
DO NOT OPEN