User's Manual
Table Of Contents
- Introduction
- 1. Getting Started
- 2. Network Connection
- 3. Bluetooth Connection
- 4. Music Sources
- 5. Control
- 5.1 The Touch Panel and Rotary Control
- Diagram 12 Touch Panel and Rotary Control
- Diagram 13 Touch Standby to switch on and off. Turn the rotary control to adjust volume.
- Diagram 14 Bluetooth stream playing
- Diagram 15 Spotify® Connect stream playing
- Diagram 16 AirPlay stream playing
- Diagram 17 TIDAL stream playing
- Diagram 18 UPnP™ stream playing
- Diagram 19 iRadio input
- Diagram 20 Local inputs
- 5.2 The Mu-so Remote Control Handset
- 5.3 The Naim App
- 5.1 The Touch Panel and Rotary Control
- 6. Installation Notes
- 7. Specifications
- 8. Acknowledgements
7
2. Network Connection
When not connected to a local wireless network, Mu-so
can broadcast its own wireless signal that can be used to
access its internal web setup page. The name and password
of the wireless network you wish Mu-so to connect to can
be specied on the setup page. To access the Mu-so setup
page wirelessly follow the steps below.
• Using the pin-tool supplied, or a straightened paper
clip, briey press the pin-hole button. The status
indicator will change colour and ash.
Note: The Mu-so wireless network broadcast will switch
o automatically after 30 minutes. It can be re-started by
pressing the pin-hole button again.
Open the computer, laptop, tablet or smart phone wireless
setup page or control panel and look for a local wireless
network called (Mu-so-XXXX-Setup). This is a wireless
network generated by Mu-so itself that enables temporary
connection for setup purposes.
Note: The default Mu-so network and Bluetooth name
incorporates the last four characters of the unique MAC
address printed on a label on the underside of each unit.
Select the Mu-so wireless network and connect to it. No
password will be required.
Note: Windows may require conrmation of network type.
Select “Home”.
• Close the computer, laptop, tablet or smart phone
wireless setup page or control panel.
• Open a web browser window on the computer, laptop,
tablet or smart phone and type 192.168.1.12 in the
address bar. Press return or select “Go”.
• The browser will display the Mu-so Setup page. Select
Mu-so Wireless Setup and type your wireless network
name and password in the appropriate dialogue boxes.
Select Enter. Diagram 9 illustrates the Mu-so Setup
page home screen.
• Close the browser window.
• Return to the computer, laptop, tablet or smart phone
wireless setup page or control panel and re-connect to
your local network.
• Disconnect and then re-connect Mu-so to the mains
power supply and wake it from standby by touching its
display Standby icon or pressing the handset Standby
button (not Mu-so Qb).
• After a few moments your Mu-so should be available
for wireless streaming on your home network. The
Mu-so status indicator will illuminate white.
Diagram 9
Setup web page - Overview