manual

E8
Mains input
and fuse
CDS3
9 CDS3 In Use
9.1 Disc Loading
To load a compact disc lift the transport lid from the front
of the player. Place the disc on the platter followed by the
magnetic puck. Do not use a puck from any other Naim
CD player.
Note: If an HDCD
®
encoded compact disc is loaded the
CDS3 will automatically recognise and decode it. The
display will read HDCD for a few seconds after play is
pressed.
9.2 Player Maintenance
It is important for reliable operation of the CDS3 to ensure
that the surfaces of the transport platter and the underside
of the puck are free of dust or debris which can prevent
the disc from sitting properly and cause it to slip.
To clean the transport platter, take a piece of Blu-Tack and
lightly apply it to the top surface of the magnetic metal
hub, picking up any material attached to it. Brush the
plastic outer edge lightly with your finger or a soft brush
to ensure that it is dust and particle free. Similarly, clean
the puck with Blu-Tack, to remove debris from the three
locating pins on its underside. Take care not to damage
the rubber pressure pads. Brush them lightly with your finger
or a soft cloth.
Do not, under any circumstances, use any solvents or fluids
for the cleaning process.
8.2 CDS3 Connected to XPS Power Supply
Note: If a CD 555PS Power Supply is used to power a CDS3
player use only power supply output Socket 1.
Cable
direction
marker
CD Burndy
Cable