Operation Manual
E8
CD5 XS
10. CD5 XS Introduction and Installation
The CD5 XS CD Player can be operated either from its internal power supply only or, for improved performance, with an
additional external Naim Flatcap or Hi-Cap power supply. Connection of the power supply is illustrated in Diagram 14.2. CD
player control and operation is described in Sections 16, 17 and 18.
The CD5 XS should be installed on a dedicated equipment stand intended for the purpose. Do not stand the player directly
on top of another item of Naim Audio equipment. Care should be taken to ensure that the player is level.
The CD5 XS is tted with both analogue and S/PDIF digital output options selectable using a rear panel switch.
A transit screw on the underside of the CD5 XS case should be removed before use and must be replaced if the unit is to be
re-packed and shipped. This transit screw must not be used in any other Naim product. Do not invert the player once the
transit screw is removed.
The player (and external power supply if used) should be installed in its nal location before connecting cables or switching
on. Ensure that power ampliers are switched o and the preamplier volume is turned down before the player (or external
power supply) is switched on. The player power button is located on the rear panel. The Flatcap power supply power button
is located on its rear panel. The Hi-Cap power supply power button is located on its front panel.
11. CD5 XS Connections
11.1 Rear Panel
Note: Icon descriptions can be found in Section 19.
Note: The power supply link plug should be tted unless
an external upgrade power supply is in use.
Note: The Remote input socket is intended to accept
external control signals for multi-room applications.
Contact your dealer or Naim Audio directly for further
information.
Note: The optional RS232 interface can provide external
control of the player in custom installations. Contact your
dealer or Naim Audio directly for further information.
ch1
ch2
-ve
nc
nc
DIN output
Note: RCA phono and DIN output
sockets should not be connected
simultaneously.