Operation Manual
E15
22. Statutory Safety Warnings
21. Declarations of Conformity
Declaration of Conformity
Naim Audio declares that Naim Audio products are in conformance with:
Low Voltage Directive 2006/95/EC
Electromagnetic Compatibility Directive 2004/108/EC
Restriction of Hazardous Substances (RoHS2) Directive 2011/65/EU
Waste of Electrical and Electronic Equipment Directive 2012/19/EC
Energy Using Product Directive 2009/125/EC
Naim Audio products comply with the following standards:
EN60065 - Audio, video and similar electronic apparatus - Safety requirements
EN55013 - Sound and television broadcast receivers and associated equipment - Radio disturbance characteristics
EN55020 - Sound and television broadcast receivers and associated equipment - Immunity characteristics
EN61000-3-2 - Mains harmonics current emissions
EN61000-3-3 - Mains icker emissions
Products that display the crossed-out wheeled bin logo cannot be disposed of as domestic waste. These products
must be disposed of at facilities capable of re-cycling them and appropriately handling any waste by-products.
Contact your local authority for details of the nearest such facility. Appropriate recycling and waste disposal helps
conserve resources and protects the environment from contamination.
In order to comply with current European safety regulations
it is essential that the Naim loudspeaker connectors
supplied with ampliers and loudspeakers are used.
Do not under any circumstances allow anyone to modify
your Naim equipment without rst checking with the
factory, your retailer, or your distributor. Unauthorised
modications will invalidate your guarantee.
Equipment must not be exposed to dripping or splashing
and no objects lled with liquid, such as vases, should be
placed on the equipment.
For your own safety do not under any circumstances open
Naim equipment without rst disconnecting it from the
mains.
Warning: an apparatus with CLASS I construction shall
be connected to a mains socket outlet with a protective
earthing connection.
Warning: batteries installed shall not be exposed to
excessive heat such as sunshine, re or the like.
Where the mains plug or an appliance coupler is used as
the disconnect device, the disconnect device shall remain
readily operable. To disconnect the equipment from the
mains remove the mains plug from the mains outlet.
The following label is attached to all mains powered
equipment:
WARNING
THIS APPARATUS
MUST BE EARTHED
This equipment has been tested and found to comply
with the relevant EMC and Safety Standards, and, where
applicable, also complies with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning
o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
• Consult your Naim retailer or an experienced radio/TV
technician for help.
To the fullest extent permitted by applicable law, Naim
Audio Ltd. disclaims all liability for any loss or damages
whether real, incidental or consequential that arise from
using this product. Naim Audio Limited, its agents and
representatives, cannot be held responsible for the loss of
any data or content from a Naim/NaimNet server, however
caused.