Owner's Manual

25. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical
attention.
26 . {} This symbol, shown on the underside label of the product, denotes that the equipment is designed primarily
for indoor use .
27 . = This symbol, shown on the underside label of the product, denotes that the USB output provides direct current
only.
28. ,-,...., This symbol, shown on the underside label of the product, denotes that the equipment is suitable for alternative
current only.
29. ~ This symbol, shown on the underside label of the product, denotes that the equipment can only be used in
locations with altitude not exceeding 2000m.
30. When the apparatus is not in use or during its relocation, take care of the power cord and plugs; e.g. tie up the
power cord with cable tie or similar. The tie must be free from sharp edges and the like that might cause abrasion
of the power cord. When put into use again ensure the power cord and plugs are not damaged. If any damage is
found the power cord and plugs should be replaced by items either specified by the manufacturer or that have same
characteristics as the original items.
31. [g] This equipment is a Class II or double insulated electrical appliance. It has been designed in such a way that it
does not require a safety connection to electrical earth.
This product can be recycled. Products bearing this symbol must NOT be thrown away )(
with normal household waste. At the end of the product's life, take it to a collection point
designated for recycling of electrical and electronic devices. Find out more about return
and collection points through your local authority. The European Waste Electrical and
Electronic Equipment (WEEE) Directive was implemented to dramatically reduce the
amount of waste going to landfills , thereby reducing the environmental impact on the
planet and on human health. Please act responsibly by recycling used products. If this
product is still useable, consider giving it away or selling it.
Guarantee Information
To the fullest extent permitted by applicable law, Nairn Audio Ltd. disclaims all liability for any
loss or damages whether real, incidental or consequential that arise from using this product. Nairn
Audio Limited, its agents and representatives, cannot be held responsible for the loss of any data
or content from a Nairn server, however caused. Do not under any circumstances allow anyone to
modify your Nairn equipment without first checking with the factory, your retailer, or your distributor.
Unauthorised modifications will invalidate your guarantee.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions :
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This product does not contain any user serviceable components. Any unauthorized product changes
or modifications will invalidate warranty and all applicable regulatory certifications and approvals,
including authority to oper~te this device.
Warning: This equipment has been tested and found to comply with the limits for a Class B digital
device , pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protect i on
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications . However there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help .
Caution: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Operations in the 5.15 - 5.25GHz band are restricted to indoor usage only.
RF Exposure Requirements: To comply with FCC requirements , a minimum separation distance of 20cm
(8 inches) is required between the equipment and the body of the user or nearby persons.
IC Statement
This Class B digital apparatus complies with Canadian ICES-003 and RSS-247. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference , and (2) This device
must accept any interference received, including interference that may cause undesired operation.