Specifications

E4
NaimUniti Installation and Connection
2.9.2 Wireless Network Connection
If NaimUniti is to connect wirelessly to the home network
thesuppliedWiFiantennamustbefittedtotherearpanel
wireless antenna socket. Wireless configuration will also
benecessarybeforeNaimUnitiisabletoconnecttothe
network.SeeSection4.6.1ofthismanual.
2.9.3 Network Settings
NaimUnitiissetupwhenoriginallyshippednottorequire
anyon-sitenetworkconfigurationbuttoconnecttoa
networkautomatically(itusesDHCPbydefault).However,
ifyourNaimUnitihasbeenpreviouslyused,itsnetwork
configurationmayhavebeenalteredleavingitunable
toconnectautomatically.Ifthisappearstobethecase
ensure that DHCP is selected in the Network Settings menu
andre-startNaimUniti.Ifproblemsstillpersistcontactyour
retailer,installerorNaimAudiodirectly.SeeSection4.6.
Note: A NaimUniti switched on without a working wired
network connection will only be able to connect to
a home network wirelessly. To use an ethernet (wired)
connection, switch NaimUniti off, connect the network and
switch it on again.
Note: For internet radio to operate NaimUniti requires
connection to a broadband internet service via a router/
modem with a built-in firewall.
2.10 Control Sockets
NaimUniti is fitted on its rear panel with a standard
RS232 interface socket and a Remote in socket. These
socketsenableNaimUnititobeintegratedwithinhome
automation systems. Contactyourretailer,distributoror
Naimformoreinformationifrequired.