Instruction Manual

When the device is started for the first time, it runs through a setup
wizard to configure settings for date/time and network. Once this
has finished, the system is ready to use.
Note: To change these settings later, select Menu > System
settings >.
To run the setup wizard again, select Menu > System settings >
Setup wizard. Select Yes to start the setup wizard.
If you choose No, the next screen asks if you would like to run the
wizard next time device is started. The system then starts without
configuring time/date and network settings and enters the Main
Menu.
Note: If power is removed while the wizard is in progress, the
wizard will run again next time the NakiRadio is started.
3.1.1 12/24 Hour Display
To change between 12 and 24 hour display, select Set 12/24 hour
and then select your preference.
3.1.2 Set Time/Date (Wizard)
The date and time are displayed as mm-dd-yyyy and hh:mm
AM/PM with the first value, mm active (flashing).
Adjust each value with the Select control. As each value is set by
pressing the Select control, the next value becomes active and
ready for adjustment.