User's Manual

43. Reconnect the two 2way connectors
on the air valves. (The plugs can go
into either socket)
44. Refit the Air Tubes to connectors A
and B. The tubes are just pushed fully
into the connectors.
45. Raise the level adjusters on the ride base and move it to the monitor cabinet. Reconnect
the Air Tube from the Ride Base to the Monitor Cabinet.
Turn the machine ON and listen for any air leaks. If there are any leaks push the air tubes
in fully until the connection is sealed.
Turn the machine OFF and disconnect from the mains.
Disconnect the air tube from the monitor cabinet and move the Ride Base away from the
monitor cabinet and lower the level adjusters again.
46. Place the Control Arm Assembly onto
the Wooden Plate and fit, finger tight,
the 8off Hex Head Screws (M8x45).
Tighten fully all of the M8x25 screws.
Note: This item is heavy. Ensure that
two people are available to replace
this item.
47. Reconnect the 3way and 15 way
connectors to the Control Arm
Assembly and make sure that the
wires are re-clipped and do not get
caught or are under strain when the
Control Arm is moved up and down.
48. Refit the rear Vac-Form using
2off Security Head Screws
(M5x16).
49. Refit the Side Vac-Forms using
the 6off Security Screws
(M5x16). (3ea side)
50. Refit the Stand-On Vac Form
using the 4off Security Screw
(M5x16) and 4off Security
Screw (M5x20).
51. Refit the Tank Vac-Form using
4off Security Head Screw
(M5x16) and 4off Security
Head Screw (M5x20).
52. Refit the Vac-Form Closing Bracket using 4off Security Head Screw (M5x16).
53. Ensure that all Security Head Screws are fully tightened.