user manual

Page 83
7-22 Replacing the Flat Target Sensor PC Board
Note: PC Boards are susceptible to damage from static electricity. Anti static
precautions should be taken when removing, handling and refitting the PC
Board.
1. Remove the Flat Target Assembly. (See Section 7-18 page 77).
2. Disconnect connectors (J301) and (J302).
3. Using needle nosed pliers, squeeze the locking tabs of the locking supports, one
at a time, to release the PC Board. Remove the Sensor PC Board.
4. Replace the board by gently pushing the board on to the locking supports.
Note: When replacing the Sensor Pc Board, ensure that connector (J301) is located at
the front.
Locking Supports
Connector
(J302)
Flat Target
Sensor PC Board
Front
Connecto
r
(J301)
Ta b
Needle Nosed
Pliers
Stopper
Locking Support
PC Board