Product Manual

CHAPTER 3: PROBLEM SOLVING The Scooter
™
2. ELECTRICAL SYSTEM
PROBLEM
POSSIBLE CAUSE
HOW TO REPAIR
No electrical power
1. Defective cord.
2. Circuit breaker off or fuse
blown or blow circuit
blower.
3. Not using 20 Amp circuit
breaker.
1. Replace
2. Turn circuit breaker on or
replace fuse. Unplug any
equipment using the same
circuit
3. Use 20 amp circuit breaker
Switch is turned on,
power is intermittent to
all motors.
1. Faulty electrical cable.
2. Defective Switch.
3. Loose terminal or corroded
connector
1. Repair or replace.
2. Replace
3. Replace
Electrical Shock
1. Equipment not grounded
1. Replace grounded outlet.
NOTE: Must use two (2) circuit breakers when using 2 power cords.
3. VACUUM SYSTEM
PROBLEM
POSSIBLE CAUSE
HOW TO REPAIR
Vacuum motor on, little
or no vacuum on suction
head (wand) or
upholstery tool.
1. Lid is not closed.
2. Hose or wand clogged.
3. Drain valve not closed.
4. Loose or no vacuum hose
connection inside the
machine.
5. Clogged ball float.
6. Lint accumulation in fans.
1. Close lid.
2. Clean
3. Push drain valve handle
down.
4. Check interior vacuum
hose & connect to the right
adapter on motor.
5. Clean filter
6. Remove & clean motor
fans.
Not enough Vacuum
Power at the machine.
1. Accumulate dirt on the ball
float cage & filter.
2. Worn out lid gasket.
3. Lint & dirt build-up on
suction head (wand).
4. Defective vacuum hose or
cracked hose.
1. Clean
2. Replace
3. Clean
4. Replace
Vacuum motor runs
intermittently.
1. Worn out brush Assem.
2. Brushes worn out.
1. Replace
2. Replace
5