Installation Guide

ManualsBrandsNameeks ManualsBathDadila 33 in. W x 17.5 in. D x 17.4 in. H Bathroom Vanity in Glossy White with Ceramic Vanity Top and Basin in White

Nuts

Insulation

Sleeve

Hanger

Bolts

(8mm)

Washer

Expansion

Anchor

Bolts

Wall Anchor

Included Sink Installation Hardware

Vanity Installation Hardware

Tools You May Need

Following these mounting instructions with the hardware included will be more than

sufficient to support vanity installation.

Level

Tape

Measure

Drill

Hammer

Phillips

Screwdriver

Caulk

Mounting

Bracket

Bottom

Mounting

Bracket

Handle

Screw

Installation Instructions

Dadila Collection

Summary of content (5 pages)

PAGE 1
Installation Instructions Dadila Collection Following these mounting instructions with the hardware included will be more than sufficient to support vanity installation.
PAGE 2
1. Prepare Location Locate studs in the wall. If the studs do not line up with the holes in the back of the sink and vanity, be sure to add sufficient wall supports behind the finished wall. 2. Mount Vanity Brackets Mark the desired height of the vanity on the wall. Mark the location of the mounting brackets and bottom of the vanity. Drill pilot holes and install the three (3) mounting brackets. Check position with a level.
PAGE 3
. Install Vanity Base Hang vanity base on mounting brackets. Use a phillips head screwdriver for adjustments and tightening. 4. Attach Vanity Handles Use a phillips head screwdriver to attach handles to vanity drawers.
PAGE 4
5. Install Hanger Bolts Measure the distance between mounting holes in the back of the sink. Drill pilot holes and screw in hanger bolts. Check the position with a level. x2 6. Mount Sink With Washers and Nuts Thread the sink on to the two hanger bolts. Secure the sink with insulation sleeves, washers and nuts. Be careful not to over tighten the bolts. Over tightening can cause the sink to chip and crack.
PAGE 5
7. Install Caulk Finish the sink installation with a bead of caulk between the sink and wall. Click-Clack Drain Faucet 8. Vanity Accessories Complete your installation by adding the preferred plumbing accessories, such as the faucet, click clack drain, p-trap and angle valves to your vanity.