Installation Guide

x4 Wall Anchor

Insulation

Sleeve

Hanger

Bolts

(8mm)

Washer

Allen

Wrench

x2 Wall Anchor

x2 Nuts

Included Sink Installation Hardware

Console Installation Hardware

Tools You May Need

Following these mounting instructions with the hardware included will be more than

sufficient to support console installation.

evel

ape

Measure

rill

ammer

Phillips

crewdriver

Caulk

rench

1 ” Screw

Installation Instructions

Console Sink

PAGE 1
Installation Instructions Console Sink Following these mounting instructions with the hardware included will be more than sufficient to support console installation.
PAGE 2
1. Prepare Location Locate studs in the wall. If the studs do not line up with the holes in the back of the sink, be sure to add sufficient wall supports behind the finished wall. x2 2. Install Hanger Bolts Measure the distance between mounting holes in the back of the sink. Drill pilot holes in wood and screw in hanger bolts. Check position with a level. 3. Secure Sink With Washers and Nuts x2 x2 x2 Thread the sink on to the two hanger bolts. Secure the sink with insulation sleeves, washers and nuts.
PAGE 3
4. Install Caulk Finish the sink installation with a bead of caulk between the sink and wall. 5. Assemble The Console Assemble the console: follow these steps below. 1 2 3 4 6. Mark Console Mounting Brackets Place the console under the sink and mark the location of the brackets on the wall. Drill the holes for mounting on marked wall.
PAGE 4
7. Mount Console Brackets If needed, install the wall anchors. Mount the brackets with the screws included. 8. Mount Console Under Sink Position the console under the sink. Mount the console to the wall bracket and tighten with included allen wrench. Faucet Click-Clack Drain 9. Sink Accessories Complete your installation by adding the preferred plumbing accessories, such as the faucet, click clack drain, p-trap and angle valves to your sink.