Installation Guide

SINK INSTALLATIONS
P: [phone]
F: [phone]
The following sink instructions are guidelines only.
Installation of a built in or drop in sink is very similar to the installation
of a vessel or supported sink. When the Vanity and countertop is
ready for the sink to be mounted, test fit the sink into the hole created
in the countertop. Draw an outline around the rim of the sink. Remove
the sink and apply a steady, continuous bead of silicon around the
opening between the line and the edge of the opening. Press the sink
firmly into the silicon and remove any excess silicon with a rag.
Connect the corresponding piping for the sink.
Build in or Drop in Wash Basins
The mounting hardware included with the sink is two 8 mm bolts with
corresponding nuts, washers and plastic sleeves. To mount the sink
onto the wall, you must locate studs in the wall and drill holes into the
wall for the corresponding bolts. If the studs in the wall do not line up
with the pre-drilled holes in the sink, you may secure a piece of wood
with angled screws to the studs so that the holes will line up properly
and ensure the stability of the mounting. The bolts will thread through
the holes already drilled in the sink and into the wall. The bolt side will
thread through the sink and secured with washers and nuts. The
screw side of the bolt will go into the plastic sleeves and into the wall.
Suspended or Wall-Mounted Wash Basins