Installation Guide

nuts

insulation

sleeve

hanger

bolts

(8mm)

washer

x2 wall anchor

Included Installation Hardware

Tools You May Need

Following these mounting instructions with the hardware included will be more than

sufficient to support wall mounted installation.

Level

Tape

Measure

Drill

Caulk

Wrench

Installation Instructions

Wall Mounted Sink

PAGE 1
Installation Instructions Wall Mounted Sink Following these mounting instructions with the hardware included will be more than sufficient to support wall mounted installation.
PAGE 2
1. Prepare Location Locate studs in the wall. If the studs do not line up with the holes in the back of the sink, be sure to add sufficient wall supports behind the finished wall. x2 2. Install Hanger Bolts Measure the distance between mounting holes in the back of the sink. Drill pilot holes in wood and screw in hanger bolts. Check postion with a level. 3. Secure Sink With Washers and Nuts x2 x2 x2 Thread the sink on to the two hanger bolts. Secure the sink with insulation sleeves, washers and nuts.
PAGE 3
4. Install Caulk Finish the sink installation with a bead of caulk between the sink and wall. Faucet Click-Clack Drain 5. Sink Accessories Complete your installation by adding the preferred plumbing accessories, such as the faucet, click clack drain, p-trap and angle valves to your sink.