Installation Guide

x2
x2
x2
x2
1. Prepare Location
Locate studs in the wall. If the
studs do not line up with the
holes in the back of the sink,
be sure to add sufficient wall
supports behind the finished
wall.
2. Install Hanger
Bolts
Measure the distance between mounting
holes in the back of the sink. Drill pilot
holes in wood and screw in hanger bolts.
Check postion with a level.
3. Secure Sink With
Washers and Nuts
Thread the sink on to the two
hanger bolts. Secure the sink
with insulation sleeves, washers
and nuts. Be careful not to over
tighten the bolts. Over tightening
can cause the sink to chip and
crack.
2