User's Manual

103
Static mode.
2. Enter the parameters: IP, Netmask, Gateway, Pri.DNS (primary DNS), Sec.DNS (second DNS) in
the corresponding fields.
3. Click Save and the pop-up box shows "System will reboot, Are you sure?".
4. Press the OK soft key to accept the change or the Cancel soft key to cancel.
To configure Network via Web interface:
1. Click Network→ Basic→ IPv4 Setting
2. Select the desired Type: DHCP or Static IP Address.
3. Fill in the necessary information.
4. Click and the pop-up box shows "System will reboot, Are you sure?".
IPv6
If you set IP Mode to IPv6, IP phone will use IPv6 address. IPv6 has two network modes: DHCP, Static
IP Address.
To configure IPv6 via Phone interface:
1. Press Menu→ Settings→ Advanced Setting (password: admin) → Network→ WAN Port→ IP Port
Mode.
2. Press or to change the IP Port Mode.
3. Press or Save soft key to save the configuration.
To configure IPv6 via Web interface:
1. Click Network→ Basic→ Internet Port
2. Select IPv6 for Internet Port.
3. Click for the setting.