User's Manual

105
To configure IPv4&IPv6 via Web interface:
1. Click Network→ Basic→ Internet Port
2. Select IPv4&IPv6 for Internet Port.
3. Click for the setting.
Note:
Wrong network parameters may result in inaccessibility of your phone and may
also have an impact on your network performance. For more information about
these parameters, contact your system administrator.
Preference (IPv4/IPv6)
When the network set as IPv4&IPv6 dual stack mode, you can set the parameter “Preference
(IPv4/IPv6)” to choose which IP protocol will be used in the higher priority.
Note: This function will only be displayed in IPv4&IPv6 dual stack, that is, when IP
Mode (IPv4/IPv6): IPv4&IPv6, the Preference function will be displayed.
To configure Preference via Web interface:
1. Click Network→ Basic→ Internet Port → Preference (IPv4/IPv6)
2. Select IPv4 or IPv6 as you prefer.
3. Click for the setting.
4. If change the Preference on webpage, a warning window will pop up, "Network settings have been
changed, are you sure reboot the phone to save changes?" Click OK, the phone will restart.
PC Port
Two modes for PC Port: bridge and Connect to Expansion Module.
To Select the PC Port via Phone interface:
1. Press Menu→ Settings→ Advanced Setting (password: admin) → Network→ PC Port→ Bridge
mode/Expansion Module.
2. Click Save and the pop-up box shows "System will reboot, Are you sure?".
3. Click the OK button, then the phone will reboot.