User's Manual
80
2. Press and key to select the Zero Touch in the Type field.
3. Press or Save soft key to save the configuration.
To configure the Zero Touch via Web interface:
1. Click Function Keys→ Line Key.
2. Select the desired Line Key and select Zero Touch in the Type field.
3. Click the button to save the configuration.
To use the zero touch feature on the user interface:
1. Press the Zero Touch key when the IP Phone is idle.
2. Press the OK soft key and the IP Phone will enter the WAN Port interface; you can change the WAN
Type by pressing the Navigation keys.
3. Press the Next soft key to enter Network interface, then you can configure some information.
4. Press the Next soft key again, you can configure Auto Provision information.
5. When you finish the setting, you can press the OK to accept the changes.
Note:
This feature is not available on all servers. For more information, contact your
system administrator.
Multicast Paging
You can use multicast paging to forward out time sensitive announcements quickly and easily to people
within the multicast group. You can configure a multicast paging key or a paging list key on the phone,
which allows you to send a Real Time Transport Protocol (RTP) stream to the pre-configured multicast
address/addresses without involving SIP signaling. You can configure the phone to receive an RTP
stream from pre-configured multicast listening address/addresses without involving SIP signaling. You
can specify up to 10 multicast listening addresses.
Sending RTP Stream
To configure a Multicast Paging key via Phone interface
1. Press Menu→ Features→ Function Keys→ Line Keys as Function Keys→ Line Key2(for example).
2. Press and or Switch soft key to select the Multicast Paging in the Type field.
3. Enter the multicast IP address and port number (e.g., 224.5.6.20:2000) in the Value field. The valid
multicast IP addresses range from 224.0.0.0 to 239.255.255.255.
4. Press or Save soft key to save the configuration.
To configure a Multicast Paging key via Web interface
1. Click Function Keys→ Line key:
2. Select the desired Line Key and select Multicast Paging in the Type field.
3. Enter the multicast IP address and port number (e.g., 224.5.6.20:2000) in the Value field. The valid
multicast IP addresses range from 224.0.0.0 to 239.255.255.255.
4. Click the button to save the configuration.