User's Manual
ZDC ZA-5000-D User's Manual V2.3.2 
Page III
FEDERAL COMMUNICATIONS COMMISSION 
INTERFERENCE STATEMENT 
This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a residential installation. This 
equipment generates, uses and can radiate radio frequency energy and, if not installed and 
used in accordance with the instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user 
is encouraged to try to correct the interference by one or more of the following measures: 
-Reorient or relocate the receiving antenna. 
-Increase the separation between the equipment and receiver. 
-Connect the equipment into an outlet on a circuit different from that to which the receiver 
is connected. 
-Consult the dealer or an experienced radio/ TV technician for help. 
CAUTION: 
Any changes or modifications not expressly approved by the grantee of this device could 
void the user's authority to operate the equipment. 
Use only shielded cables to connect I/O device to this equipment. You are cautioned that 
changes or modifications not expressly approved by the party responsible for compliance 
could void your authority to operate the equipment. 
RF exposure warning 
This equipment must be installed and operated in accordance with provided instructions 
and the antenna(s) used for this transmitter must be installed to provide a separation 
distance of at least 20
  cm from all persons and must not be co-located or operating in 
conjunction with any other antenna or transmitter. End-users and installers must be provide 
with antenna installation instructions and transmitter operating conditions for satisfying RF 
exposure compliance. 










