User's Manual
ZDC ZA-5000-D User's Manual V2.3.2 
Appendix B Glossary 
Page 49
Appendix B.  Glossary 
Diagram 12 Glossary 
Glossary  Expiation 
802.11a IEEE specification for wireless networking at 54 Mbps using direct-sequence 
spread-spectrum (DSSS) technology and operating in the unlicensed radio 
spectrum at 5GHz. 802.11a provides specifications for wireless ATM systems 
and is used in access hubs.   
Networks using 802.11a operate at radio frequencies between 5.180 GHz and 
5.825 GHz. The specification uses a modulation scheme known as orthogonal 
frequency-division multiplexing (OFDM) that is especially well suited to use in 
office settings. In 802.11a, data speeds as high as 54 Mbps are possible. 
Access Point   In a wireless local area network (WLAN), an Access Point is a station that 
transmits and receives data (sometimes referred to as a transceiver). An Access 
Point connects users to other users within the network and also can serve as the 
point of interconnection between the WLAN and a fixed wire network. Each 
Access Point can serve multiple users within a defined network area; as people 
move beyond the range of one Access Point, they are automatically handed over 
to the next one. A small WLAN may only require a single Access Point; the 
number required increases as a function of the number of network users and the 
physical size of the network. 
Infrastructure In the infrastructure mode, the wireless access point converts airwave data into 
wired Ethernet data, acting as a bridge between the wired LAN and wireless 
clients. Connecting multiple Access Points via a wired Ethernet backbone can 
further extend the wireless network coverage. As a mobile computing device 
moves out of the range of one access point, it moves into the range of another. 
As a result, wireless clients can freely roam from one Access Point domain to 
another and still maintain seamless network connection. 
ESS  Short for the extended service set, One BSS or more builds one ESS. A station 
can connect or roaming ESS by ESSID of AP. 
WEP  Wired Equivalent Privacy is a data encryption protocol for 802.11 wireless 
networks. All wireless nodes and access points on the network are configured 
with a 64-bit, 128-bit or 152-bit Shared Key for data encryption. 
Access Control  This function is only valid under AP mode, invalid under the mode of bridge 
graft. Used in MAC address to filter. 
Bridge  Bridge is the device that connects and transmits data packets with two subnets 
by the same protocol and it works in the LLC layer of OSI. 
DHCP 、 DHCP 
Client 、 DHCP 
Server 
DHCP stands for "Dynamic Host Configuration Protocol".   
DHCP's purpose is to enable individual computers (DHCP Client) on an IP 
network to extract their configurations from a server (the 'DHCP server') or 
servers, in particular, servers that have no exact information about the individual 
computers until they request the information. The overall purpose of this is to 










