User's Manual

ZDC ZA-5000 User's Manual V2.2.5
Chapter 2 Hardware Installation
Page 6
Chapter 2 Hardware Installation
System Requirement
 Two PCs with RJ-45 connector NIC supporting the transfer rate of 10/100Mbps data.
 The IP address of NIC should be the same subnet with the AP, the default IP address of AP is
192.168.0.228.
 Microsoft Internet Explorer 6 updated with Service Pack 1 or the newer patch Q323308.
Product Kit
 Wireless Device×1
 Power Module×1
 Fixed settings×1
 Product CD×1
Hardware Installation
Take the following steps to set up the ZA-5000-E (the different of hardware installation between
ZA-5000-E and ZA-5000-I is antenna.).
1. All the parts of product are shown as following picture.
2. You should fix the Access Point, the following figure shows it.
3. Put a Cat-5e STP (Shielded twisted pair) cable with RJ-45 connector through the water-joint.
If there no such cable, Make the RJ-45 connector as the following rules:
white orange∣orange white green∣blue white blue∣green white brown∣brown