User's Manual

ZG-7600H-P User Manual
Chapter 4 Basic Configuration
Page 9
 802.11g Only: Setup 802.11g network and only 802.11g STA could connect up it.
 802.11b Only: Setup 802.11b network and only 802.11g/b STA could connect up it.
 Auto(11g and 11b):Setup 802.11g/b network and only 802.11g/b STA could connect up
it.
 Beacon Interval
Specifies the interval time (20 ~1000ms) for each beacon transmission.
 DTIM Interval
The Delivery Traffic Indication Message, Specifies the data beacon rate between 1 and 255.
 WMM Support
Enable this option can ensure the throughput of the voice and video data stream.
 Number of Wireless Stations Allowed to Associate
This feature could control STA connection. While the number is more than the max value, it
will stop STA connecting.
 Radio Enable
When disable radio, device will stop sending beacon.
 Output Power Management
Adjust the transmit power of the Access Point. The more the Output Power the more area of
the wireless signal can reach
 Data Rate Management
To set device’s send data rate, the default value is Best. The available transmit data rate of the
wireless network. You also can choose lower data rate in order to transmit data in longer
distance.
 Preamble Type
A long preamble ensures compatibility between the access point and all early Wireless LAN
Adapters. And Auto include Short and Long preamble.
 Super-G Mode
Super-G mode provides higher speed transmissions than regular IEEE 802.11g. The other
device must also support Super mode in order for the device to use it for the wireless
connection. This is available when you select a Wireless Mode that includes IEEE 802.11g.
 Turbo-G Mode