User's Manual

5、Notice
1) Please do not place any object on the fixture or allow liquid to flow inside the fixture.
2) Please do not place the fixture near any flammable or volatile substances like alcohol or
gasoline.
3) Please do not use strong detergent for cleaning. Please wipe off the dirt by using a cloth with
neutral cleanser when cleaning the fixture.
4) Please set up the fixture in a dry and well-ventilated place. Please do not use it in any humid,
dusty or overheated environment. The temperature of the environment for the PavoTube Ⅱ 30C
should not be higher than 40℃. Please do not operate or store the fixture around objects with
high heat.
5) Please do not disassemble the fixture at will to repair by yourself. Qualified professionals
should conduct maintenance under the condition of strictly following the operating procedures
described in this manual.
6、FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.