Instructions / Assembly
flash). This is disabled 15 minutes after the light is powered up for security.
You can also match the ID# on your Downlight with the last 3 digits of a device
name on the app.
2.5 The Nanoleaf app will pair with the device and ask you for permission to access
your network to check for available Thread networks, and then provision the device
to Thread if one is available.
2.6 Name your device and assign it to a room.
2.7 If a smart home hub and compatible Thread border router are present in the
home and detected by the Nanoleaf app, you will be provided with the option to
connect your light to Matter. Otherwise, you will be taken back to the Dashboard.
2.8 Continue with the following steps if you’re presented with the “Add To An
Ecosystem” screen:
Option A
Tap “Connect”
Option B
On Android, you will be shown a menu with the following:
● Options for supported apps for direct pairing (select one and you’ll be directed
through the setup flow in that app)
● “Use pairing code” - select this if the app you want to pair with is on the same
phone/tablet but doesn’t show up in the list, copy the code, and paste the code
into the app you want to pair with.
● “Use QR code” - select this if the app you want to pair with is on a dierent
phone/tablet, then open the app on your other device and scan the new QR
code.
Option C
Alternatively, you can do this at a later date by accessing your Downlight settings
within the Nanoleaf App and tapping Connections.
2.9 Pairing must be initiated within 15 minutes of the light being powered on.
Disconnect and reconnect your lights from power to re-enable Matter pairing (this
only works when the device has not already been paired via Matter).
12