Specifications

5.3 Fan at the boom of the case
If you want to mount a 120 or 140 mm fan at the case boom, you must remove the secondary
hard drive cage mounng rail located at the boom. The rail is aached with four screws to
the boom.
Please place the fan on the inside of the case and secure it from the outside.
The dust lter at the boom can be pulled out for easy cleaning.
An addional case fan at the boom of the case should be mounted so that cooler air is
introduced into the case (fan rear side facing inwards).
5.4 Fan in the side panel
If you want to accommodate a fan in the side
panel, remove the outer cover by loosening
the screws on the inside. The dust lter can
remain in its posion.
Please place the fan on the inside of the
side panel above the dust lter and secure it
from the outside.
If you secure the cover in the side panel again aer the removal of a side fan, please make
sure not to ghten the screws not too much. To avoid damage to the internal thread or the
side panel, the screws should be ghtened by hand only.
12