Specifications

EN
You can remove the fan by pushing away the
retaining lugs a li le bit from the fan and then
pull the fan out (picture 6B).
The dust  lters can easily be pulled out, as
you can see here (picture 6C).
Please note, that the  lter elements must be fully inserted to guarantee the proper opera -
on of the “Easy Access Panel”.
6.2 Fans under the top cover
If you want to install addi onal fans at the top of the case, please remove the Nanoxia VentCo-
vers  rst by removing the screws on the outside of the case.
Next, hold the fans from the inside and secure them to the top by fastening the screws from
the outside.
Case fans installed at the top of the case should exhaust air out of the case (fan rear side
facing outwards).
6.3 Fan at the bo om of the case
You can install a 120 or 140 mm fan on the bo om of the case. To do that, you must remove
the secondary HDD-cage moun ng rail from the case bo om. We recommend the following
procedure:
a) Remove the dust  lter and unscrew the
screws on the two guide rails of the  lter to
remove it.
picture 6B picture 6C
13