Operation Manual

3. Power Operation Instructions

NAPA DAV311 comes with a DC transformer in the package (as shown below).

Plug the power cord into an A/C socket, and the other end into the DC input jack

of the player.

Attention: The DC transformer accompanies with the package is given

according to the local voltage supply of different areas. Please verify

carefully if the DC transformer in the package meets the requirement of

your local area. Exchange it from your dealer if it is not the correct one.

1, The player operates by 2 sources of power supply: DC power supply

connector, or, 2 x 2A Ni-MH battery.

Using DC Power Supply Connector:

First of all, properly connect DAV311 with the DC power supply connector

provided with the package. Press “PLAY” to start operating DAV311. To turn off

the power, simply press “STOP”. Each time when finished using DAV311, it is

suggested to disconnect the player with the DC power supply connector.

Using 2 x 2A Ni-MH Battery:

Whenever DAV311 is not connecting with the DC power supply connector, the

Ni-MH battery will start to operate automatically. Press “PLAY” to start

operating DAV311. To turn off the power, simply press “STOP”. However, for

first time using DAV311, the battery has to be charged for at least 15 hours.

2. Battery Charge

First of all, properly connect DAV311 with the DC power supply connector

provided with the package. DAV311 will then detect the level of power of the

Ni-MH battery. In case if the power level is detected as lower than the standard,

the battery will be charged automatically. Once the charging starts, the LED on

DAV311 (little dot beside the LCD) will be on to indicate the charging is in