User's Manual

10
WI1024J 2WAY-UNIVKF Installation Instructions
STEP 2
- ENROLLING KEYFOBS--With NAPCO "K Series" Keypads
Enrolling and Removing KeyFobs
Each KeyFob must be enrolled into the receiver. The following procedure is used to enroll the unique RF ID number
stored in the non-volatile memory of each KeyFob into the receiver memory.
1
Arm system from any keypad
2
Disarm system from any keypad
3
Press
1114
U
on keypad
The Enroll Mode LED will flash rapidly.
The keypad will give error beeps - ignore.
4
Press the
∗
button on KeyFob 1
The KeyFob will sound a single confirmation beep.
....
Repeat for each KeyFob to be enrolled
Press C on Keypad Exit Enroll Mode - the Enroll Mode LED will slowly pulse. The
KeyFob will give a series of beeps and the unlock icon will
display.
•
The Keyfob Enroll Mode may also be entered / exited by pressing the the Enroll Mode Push Button on the top of the
receiver. See page 18 for more information.
• To Remove a lost KeyFob from the system: Enter and then exit the Keyfob Enroll Mode (Arm and disarm the
system, enter 1114
U
and then press C). All keyfobs will be deleted from the system.
For NAPCO "Classic" Keypads, see pages 9 and 12.
For Ademco Keypads, see pages 11 and 14
Bus Mode Operation
NAPCO "Classic" Keypads NAPCO "K Series" Keypads
GEM-RP1CAe2, GEM-RP2ASe2,
GEM-RP3DGTL
GEM-K1CA, GEM-K2AS,
GEM-K3DGTL, GEM-K4RF
2WAY-UNIVKF_WI1024J.19_I...
page 10
Friday, February 13, 2004 08:57
Composite