User's Manual

Wave network previously started by a "primary" controller (from any manufacturer).

Note: As the signal strength between the IBR-ZREMOTE controller and its devices is crucial, we recommend all devices

be mounted in their final installed locations before they are included into the network.

Ordering Information

• IBR-ZREMOTE: Bus-Mount Module for remote control, up/download of security system, plus control of Z-Wave

devices, lights, locks, thermostats, etc.

• IBR-ITAB: iBridge Wireless Touchscreen Tablet with mounting frame and charging station.

• IBR-ITABKIT Kit: iBridge Wireless Touchscreen Tablet with mounting frame/charging station plus Wireless Access

Point (ISEE-WAP).

• IBR-ITAB-HW: Hardwired iBridge Touchscreen Tablet version for permanent mounting and for a more conventional

hardwire installation.

• ISEE-WAP: Wireless Access Point for wireless communication between IBR-ITAB and wireless cameras.

• IBR-ITABSTAND: Angled tabletop stand/docking station for use with IBR-ITAB Touchscreen (not included). Décor-

neutral and ideal for bedrooms, kitchens, desks, etc.

• IBR-WIFI-MOD: Wireless Panel Interface, communicates between Internet, Gemini Control Panel and IBR-ITAB

Touchscreen Tablet, when NO remote services or Z-Wave are required (Note: For remote services and Z-Wave, use

the IBR-ZREMOTE).

For an iBridge Z-Wave Evaluated Device List, see our website at www.napcosecurity.com/ibridge.html. Although all Z-

Wave appliances should comply with the Z-Wave standard, we recommend that you install only Napco evaluated devices,

especially the more complex devices such as thermostats and door locks.

Specifications

Dimensions: 1½" x 7" x 4¾" (HxWxD)

Input Voltage: 13.0-10.0VDC.

Input Current: Maximum current (@ 8VDC) = 185mA

Nominal current: @ 12VDC = 185mA (supplied by control panel connections).

Available panel combined auxiliary current is reduced by 185mA.

Outputs: PGM-style open collector (negative trigger) with a maximum sink current of 50mA.

Factory Default Settings

The IBR-ZREMOTE factory default settings for the NL-MOD and NL-RCM modules are:

• Account ID = FFFFFF

• Dealer ID = NAP0000

• Keypad Address = 1

• Keypad Type = RP1CAe2

• PC Preset / DNS IP Address = 72.3.180.2

• PC Preset / DNS Port = 5002

• PC Preset / DNS Check-In Time = 1

• iBridge Server IP Address = 208.109.208.163

• iBridge Server Port = 5011