Home Security System User Manual

THIS MANUAL INCLUDES FEATURES WHICH ARE ONLY AVAILABLE IN
GEM-P1664 CONTROL PANEL FIRMWARE VERSION 1.0 OR LATER.
NAPCO Security Systems, Inc.
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service, call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com
Refer to accompanying GEM-P1664 Programming Instructions (WI1422 and WI1423) for programming information.
IMPORTANT NOTICE
GEM-P1664 panel version 01 requires the use of the following version keypads:
GEM-RP1CAe2 Version 9A, GEM-K1CA Version 9A
GEM-RP2ASe2, Version 7, GEM-K2AS, Version 7
GEM-RP3DGTL, Version 3, GEM-K3DGTL, Version 3
GEM-RP4RF, Version 2, GEM-K4/K4RF, Version 2
Upon entering program mode, the keypad display will flash the control panel firmware version, followed by the keypad firmware
version:
GEM-RP1CAe2: [019A], GEM-RP2ASe2: [0107], GEM-RP3DGTL: [0103], GEM-RP4RF: [0102]
GEM-K1CA: [019A], GEM-K2AS: [0107], GEM-K3DGTL: [0103], GEM-K4/K4RF: [0102]
For consistency, it is recommended that all keypads either be all "classic" (such as the GEM-RP1CAe2 key-
pad) or all "K Series" (such as the GEM-K1CA)--both keypad types should not be used in one alarm system.
CHANGES FROM PREVIOUS EDITION
The following changes have been made to this manual (WI1424A) since the previous edition (WI1424):
Page 6: Specifications: Current ratings updated.
Page 59: Wiring Diagram updated.